how do i change oil on a push lawn mower?

ap ush lawn mower was given to me and oil in it needs to be change, how do i change the oil? what type of oil do i use?
where can i get more info on this?

Comments

4 Responses to “how do i change oil on a push lawn mower?”
  1. Michael says:

    Transfer the doohickey to the frensic side of the transom. Then swap the whatchamacallit out with a new thingamabob. Finish it off with fresh franistan and you’re done!

  2. Carl says:

    A push mower uses 30 w oil with detergent.
    Don’t use 10 w 30
    First to be safe pull the spark plug wire on the engine!
    Then look for the drain plug under the mower.

  3. Mr.K says:

    your lawnmower takes 4cycle oil which can be found at wal-mart, C-tire or any place that sells small equipment.

    at the base of the engine you will see a little square headed bolt about as thick as a pencil. unscrew it and open the oil fill plug. once all the oil is out you can tighten the plug and refill the oil crankcase.

  4. Paul L says:

    First thing to do is remove the spark plug wire. Place a small piece of tape between the plug & the wire. Lift up the mower and look at the bottom near the shaft. There is usually a 1/2 plug to drain the oil. Sometimes on new models the plug is located on the top side of the deck near the bottom of the engine. Most mowers use a 30 SAE oil, refer to your owners manual for quantity & specs.


 
Powered by WordPress Lab